|

|
|
PLYLOX™ Commercial Applications
|
- Board up aluminum-framed windows without drilling or screws
- PLYLOX™ works with aluminum-framed window casings that are at
least 1-1/2 inches deep
- Protect your property from hurricane-force wind and rain with
PLYLOX™ Clips!
|
|
Experts say:"Board up your
windows"
Once your windows break, the storm is inside your business. |
|
 |
| PLYLOX™ should be used with 3/4" plywood. Use CDX
grade, or better, plywood that is in good condition. Do not use
plywood that has delaminated, is easy to bend, or is badly warped.
|
| Step 1 |
| Measure the length and width of each window.
Subtract 1/2" from the width measurement and 1/4" from the height
measurement. Record the measurements in this
measurement chart. |
| Step 2 |
| Cut the plywood covers for each window. Some
hardware stores will cut the plywood for you. Use good quality (CDX
or better) 3/4" plywood. Plywood comes in 4' x 8' sheets. Windows
bigger than 48" x 48" will require 2 or more sections of plywood.
Each section can be hung independently (more clips) or they can be
spliced together (more work). |
|
 |
| Step 3 |
| Slide the PLYLOX™ clips on to opposing edges
of the plywood cover. |
|
 |
| The average window requires 4 clips. Space the
clips no more than 36" apart. The thickness of plywood varies
with humidity. This will cause the clip to fit differently
from time to time. If the fit is loose, tap on the clip with a
hammer to close the opening. If the fit is tight, then force
the clip on by tapping the clip on with a hammer. |
|
 |
| Step 4 |
| Using an Allen Wrench, extend the set
screws on all the clips on one side of the plywood cover
1/4". On the opposite side of the plywood cover make sure
the set screws are flush on the clips. Insert the plywood
cover into the aluminum window casing until the clip
touches the frame. |
|
 |
Using a 5/32 Allen wrench, firmly tighten the flush set
screws. Then tighten the set screws on the opposite side at
least 1/2 turn. |
| Removing PLYLOX™ is
easy! |
| You can remove PLYLOX™ clips quickly and
easily. Use the Allen wrench and loosen the set screws.
This releases the PLYLOX™ clip and the plywood is easily
removed. The PLYLOX™ clips can then be stored and reused
the next time you are threatened. |
| |
| PLYLOX™ is not responsible for any
collateral damage sustained by the home or business due to
either misuse of the product or any unforeseen or
extraordinary natural occurrence or other act of God. |
|
|
|
|